Civinfo - View Single Post

stubbs · 25th February 2008, 11:45

I found on saturday that the rear nearside wheelarch moulding had become detatched from the rear bumper moulding of my 1.8se,how I'm not sure as I do not remember any loud noises when driving.
I have put it back together but the two mouldings do not line up it looks as if they should clip together but no clips(possibly broken off).The wheel arch trim sits proud of the bumper trim.
Is this a difficult job to do and any ideas how much a dealer would charge to do this.
Is this a common problem and if so any suggestions as to how to stop this happening again.

25th February 2008, 11:45	#1 (permalink)
stubbs Valve Cap Join Date: 25th February 2008 Location: bexhill-on-sea Posts: 1 Thanks: 0 Thanked 0 Times in 0 Posts iTrader: (0)	Wheel arch mouldings I found on saturday that the rear nearside wheelarch moulding had become detatched from the rear bumper moulding of my 1.8se,how I'm not sure as I do not remember any loud noises when driving. I have put it back together but the two mouldings do not line up it looks as if they should clip together but no clips(possibly broken off).The wheel arch trim sits proud of the bumper trim. Is this a difficult job to do and any ideas how much a dealer would charge to do this. Is this a common problem and if so any suggestions as to how to stop this happening again.