Quote:
Originally Posted by amronno
Where are the pics and a 'how to' allan,  I just can't wait till I get my hands on a piece of that brake light decal...   |
It's doesn't really need pictures.
Just hold the complete LED strip and stick some black PVC tape all around the red edge after affixing the HONDA/CIVIC mask to the LED lens (instructions with lens mask). I held the end of the tape under my thumb and pulled the tape all around before cutting off.
One point to note though: The plug on the fly lead to the LED is in held in place by a VERY small concealed latch and it difficult to find initially. The plug body
remains in place on the LED unit you only have to remove the
fly lead plug on the power supply wire. I mention this as there is also a latch that removes the complete plug from the LED unit, but still leaves it all connected.
PS: You will find a little excess to the mask. I did NOT cut this off as it laps slightly over the lens edge (smooth over the edge after ensuring all/any air bubbles are squeezed out). This enables the black PVC tape to cover neatly giving a light-proof seal