When fitting the wiring loom under console there are two multi plugs one for each switch with console removed dissconect cig/ lighter, remove four screws and the blanking plate, drill two 20mm holes in the two blanks and clean up with small file press fit the two round switchs refit blanking plate to console.The two black wires fix to a good metal earth still under the console.By the way the switchs do not light up they are rocker type.Cable tie the two fuse holders to existing loom.
If you find there is to much wire hanging about you can push it under the carpet you may have take the four bolts and lift the seats to do this.
Next step take the two red wires and join them, >you will need to purchase one metre of red wire same as loom because the loom is not long enough.< Join to the other two and solder. feed wire under side console to present loom secure with cable ties. Then connect the red wire to the yellow on the ignition switch,you can get one of those crimps to join it.
you will have to partly remove the steering barnicle to get to the swich
three screws.
The heaters are then dead untill you swich on ignition.
