How to Install Fog light Kit Outside
Kit out of box
outofbox.jpg
First Remove the flaps under bumper, One Screw Two Studs (both sides)
flapin.jpg
flapout.jpg
flapaway.jpg
Then undo the screw and stud for the arch cover and carefully unclip cover to wing. (Both Sides)
archtrim.jpg
Then remove two bolts and two studs on the underside of the bumper and the screw at the top of the bumper behind the arch cover, then gently prise off bumper, its just clipped across the top.
nobumper.jpg
If you have headlight washers you will need to detach pipework and cap to avoid loosing all your washer fluid.
pump.jpg
The inside of the bumper is stamped where the holes go so drill small pilot hole
pilots.jpg
Then drill 20mm holes from the outside, remove plastic covers and fit fog lights using bolt supplied,
bigholes.jpg
Remove more studs from inside offside wheel arch to move liner enough to get behind washer bottle and locate blue cable with loose connector and attach light loom
extconn.jpg
tankcable.jpg
Feed loom across front and attach earth cable
earth.jpg
Clip to inside of crossmember and through to nearside
passconn.jpg
Refit bumper connecting fog lights and reattaching washer hose reversing above procedure.
Inside
Remove end trim from dash and remove screw
sidepanel.jpg
Prise off lower dash cover and locate mounting bolt
mounting.jpg
Fit relay bracket attach relay and plug blue cable into switch loom (Relay centre bottom Connector centre top)
relay.jpg
Remove multiplug from above fuse box (second one up) and fit two cables from loom into plug, refit plug and put supplied fuse in number 6
fusebox.jpg
Remove three screws under steering wheel and remove cowling,
Remove screws in stalk and replace with one in kit.
stalkrem.jpg
Box it all back together and there you go mission complete.
finishedjob.jpg
The installation instructions are here (pdf, 664k):
foginstall.pdf