Speakers speaker adapter drawing ?

skidmark · 21st January 2008, 16:32

Could anyone help with a drawing or dimensions for front and rear speaker ring adapters...I would prefer to make the adapters before I carry out the mod so I don't have to remove the door panels twice.

Also..how are the speakers fixed?... bolts or self tappers

Many thanks

Munro · 21st January 2008, 17:56

The dimensions of the openings are on this link:
Info - Pics of inside door panel with speakers - Civinfo Wiki

You can measure your own speakers to make the support rings. I made some out of 19mm MDF, see this link:
Rear Speakers - Replacement with Coaxials (3 Door)

I used the self tapping screws / clips that came with the infinity speakers. Holes were pre drilled in the door panel first + a bit of waxoyl to stop corrosion.

Hope this helps.

21st January 2008, 16:32	#1 (permalink)
skidmark Valve Cap Join Date: 20th June 2007 Posts: 14 Thanks: 0 Thanked 0 Times in 0 Posts	speaker adapter drawing ? Could anyone help with a drawing or dimensions for front and rear speaker ring adapters...I would prefer to make the adapters before I carry out the mod so I don't have to remove the door panels twice. Also..how are the speakers fixed?... bolts or self tappers Many thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads for: speaker adapter drawing ?
Thread	Thread Starter	Forum	Replies	Last Post
Head Unit adapter Double Din	ulysse13	Ipods, MP3 Players and ICE	38	21st April 2008 12:27
AUX in ipod adapter question	isk85	Ipods, MP3 Players and ICE	4	6th November 2007 00:44
Phone Autoleads adapter for Bluetooth kits	karlak	Electronics	7	8th October 2007 09:04
AUX in Ipod Adapter	Griffyn	Ipods, MP3 Players and ICE	23	6th May 2007 19:52
AUX in I Pod Adapter	civichbtun	Ipods, MP3 Players and ICE	1	29th April 2007 18:39


This thread is about: speaker adapter drawing ?, it's in Ipods, MP3 Players and ICE at the Honda Civic forum Civinfo; Could anyone help with a drawing or dimensions for front and rear speaker ring adapters...I would prefer to make the adapters before I carry out ...

21st January 2008, 17:56	#2 (permalink)
Munro Supporter Rocketship door handle Join Date: 10th August 2007 Location: Scotland Posts: 1,027 Thanks: 20 Thanked 16 Times in 12 Posts	The dimensions of the openings are on this link: Info - Pics of inside door panel with speakers - Civinfo Wiki You can measure your own speakers to make the support rings. I made some out of 19mm MDF, see this link: Rear Speakers - Replacement with Coaxials (3 Door) I used the self tapping screws / clips that came with the infinity speakers. Holes were pre drilled in the door panel first + a bit of waxoyl to stop corrosion. Hope this helps.