HID Think I found the adjusters for the HID Lights - Page 2

Miggins · 6th November 2006, 18:17

Quote:

Originally Posted by Deemon

Miggins, The adjustment is not made via the rubber knobs but by an Allan Key type screw further back and down into the engine compartment a few inches further in than the rubber thing. It was a white plastic screw head it I remember correctly, have a look just behind the rubber bits and you should see it.....I will post up a pic when I get a mo..

Hello Deemon,
Sorry - only just picked up on your post. I think I know which adjusters you mean. Do you know what the rubber knobs are for? I'm sure they made some difference but not enough!

damianscott71 · 9th November 2006, 00:28

Miggins,

Did the adjusters work? I need to do mine before I drive into a tree, or worse, 2 trees.

Damian

Miggins · 9th November 2006, 11:47

They did but there was very little improvement as the lights were so close to the max height already. Still not sure what purpose the rubber knobs serve - poss just a fine adjustment.

Need to have a look at the keyed adjusters. I haven't needed to tweek these on other vehicles . . . mmmm!!!!!

Miggins · 9th November 2006, 15:12

OK just examined the adjusters mentioned by Deemon (thanks Deemon

)

It appears the main and dip beams can be adjusted independantly using a 6mm hex key.

I will try this tonight and report later with results/pictures (After resetting the rubber headed screws back to what they were).
++++++++++++++++++++++++++++++++++++++++++++++++++ +++++++++++++++++++
UPDATE:
Adjusted the white hex head that sits directly behind the dipped beam and up the beam came. One full turn clockwise with a 6mm hex key and the beam went from useless to approx what I believe is safe and legal (mmm!)

I didn't go to flat and level ground to adjust as I was only incresing the height (lateral setting is ok) and wound each side up the same measured amount (easy to put back if wrong). Photos dont show anything as its hard to see a difference when the wall/garage is only 6ft away!

After winding the adjuster in half a turn clockwise and a test drive, I realised another half turn was required - now dipped beam is lighting up the rear bumper of other vehicles from abot 30ft ~ 10m away. I believe the static setting is now correct but 'enthusiastic' accelerating results in possible dazzling of oncoming drivers. Need to assess this on a longer drive.

Picture of the adjuster later when my other half gives ME, MY car back - she seems to like it!!

I'm a lot happier and safer!

damianscott71 · 11th November 2006, 20:10

Just done mine 3/4 turn clockwise, don't want to dazzle people with my constant enthusiastic acceleration!

Damian

Maldax · 13th November 2006, 23:15

Just given mine a tweak! So much better!

joora · 19th November 2006, 02:11

Can anybody put a picture of the adjusters?

Miggins · 19th November 2006, 03:03

Quote:

Originally Posted by joora

Can anybody put a picture of the adjusters?

Pic as requested - unfortunately by battery died and with no flash the camera would focus!

The vertical adjuster sits directly behind the outer/dip lamp. Circular/white with a 6mm hex head. The other adjuster (probably for lateral adjustment) sits behind the main beam. Both are facing upwards.

Better pic tomorrow in the warm sunshine (mmm!)

IWANTACIVIC · 19th November 2006, 03:13

at miggins , there might be sunlight tommow but not a lot of warmth i bet if its like today . yer i got used these same looking adjusters to setup my last car 1 job i got to do on the civic.

FWH · 18th August 2007, 08:34

On my car there is very clear labeling of these on the black plastic which covers the lights etc under the bonnet. The inner ones are marked L-R and outer ones Up-Down.

9th November 2006, 11:47	#23 (permalink)
Miggins Enthusiastic Supporter Magic Rear Seat Join Date: 25th August 2006 Location: The Twilight Zone Posts: 531 Thanks: 0 Thanked 1 Time in 1 Post iTrader: (0)	Homer, Homer Simpson, he's about to hit a chesnut tree. . . . argghh!!! They did but there was very little improvement as the lights were so close to the max height already. Still not sure what purpose the rubber knobs serve - poss just a fine adjustment. Need to have a look at the keyed adjusters. I haven't needed to tweek these on other vehicles . . . mmmm!!!!!

9th November 2006, 15:12	#24 (permalink)
Miggins Enthusiastic Supporter Magic Rear Seat Join Date: 25th August 2006 Location: The Twilight Zone Posts: 531 Thanks: 0 Thanked 1 Time in 1 Post iTrader: (0)	The true adjusters? OK just examined the adjusters mentioned by Deemon (thanks Deemon ) It appears the main and dip beams can be adjusted independantly using a 6mm hex key. I will try this tonight and report later with results/pictures (After resetting the rubber headed screws back to what they were). ++++++++++++++++++++++++++++++++++++++++++++++++++ +++++++++++++++++++ UPDATE: Adjusted the white hex head that sits directly behind the dipped beam and up the beam came. One full turn clockwise with a 6mm hex key and the beam went from useless to approx what I believe is safe and legal (mmm!) I didn't go to flat and level ground to adjust as I was only incresing the height (lateral setting is ok) and wound each side up the same measured amount (easy to put back if wrong). Photos dont show anything as its hard to see a difference when the wall/garage is only 6ft away! After winding the adjuster in half a turn clockwise and a test drive, I realised another half turn was required - now dipped beam is lighting up the rear bumper of other vehicles from abot 30ft ~ 10m away. I believe the static setting is now correct but 'enthusiastic' accelerating results in possible dazzling of oncoming drivers. Need to assess this on a longer drive. Picture of the adjuster later when my other half gives ME, MY car back - she seems to like it!! I'm a lot happier and safer! Last edited by Miggins; 10th November 2006 at 11:45. Reason: UPDATE

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads for: Think I found the adjusters for the HID Lights
Thread	Thread Starter	Forum	Replies	Last Post
Found a card under your wiper?	Pottsy	Was it you?	36	26th June 2008 02:28
Found This Classified Ad	beepee	Any non Civic chat here please!	10	15th April 2007 09:23
Satnav List of errors found with sat nav - old vs new	TTDegs	Electronics	16	5th March 2007 20:47
Oooohhh look what i found!!	Andrea	Site suggestions, feedback and rules	20	17th December 2006 21:02
finally found an 06 forum :)	daiashthomas	Introduce yourself	8	16th October 2006 08:01


This thread is about: Think I found the adjusters for the HID Lights, it's in Lights at the Honda Civic forum Civinfo; Originally Posted by Deemon Miggins, The adjustment is not made via the rubber knobs but by an Allan Key type screw further back and down ...

9th November 2006, 00:28	#22 (permalink)
damianscott71 Diesel Demon Triangular Exhaust Join Date: 1st July 2006 Location: Kempston, Bedfordshire Posts: 470 Thanks: 2 Thanked 3 Times in 3 Posts iTrader: (0)	Miggins, Did the adjusters work? I need to do mine before I drive into a tree, or worse, 2 trees. Damian

11th November 2006, 20:10	#25 (permalink)
damianscott71 Diesel Demon Triangular Exhaust Join Date: 1st July 2006 Location: Kempston, Bedfordshire Posts: 470 Thanks: 2 Thanked 3 Times in 3 Posts iTrader: (0)	Just done mine 3/4 turn clockwise, don't want to dazzle people with my constant enthusiastic acceleration! Damian

13th November 2006, 23:15	#26 (permalink)
Maldax Supporter Rocketship door handle Join Date: 12th June 2006 Location: Reading, Berks Posts: 1,051 Thanks: 0 Thanked 0 Times in 0 Posts iTrader: (0)	Just given mine a tweak! So much better!

19th November 2006, 02:11	#27 (permalink)
joora Wheelnut Join Date: 11th September 2006 Location: Croatia Posts: 73 Thanks: 0 Thanked 0 Times in 0 Posts iTrader: (0)	Can anybody put a picture of the adjusters?

19th November 2006, 03:13	#29 (permalink)
IWANTACIVIC Supporter Magic Rear Seat Join Date: 16th September 2006 Location: LINCS UK Posts: 658 Thanks: 0 Thanked 0 Times in 0 Posts iTrader: (0)	at miggins , there might be sunlight tommow but not a lot of warmth i bet if its like today . yer i got used these same looking adjusters to setup my last car 1 job i got to do on the civic.

18th August 2007, 08:34	#30 (permalink)
FWH Super Moderator Civinfo master Join Date: 3rd June 2007 Location: Sweden Posts: 6,037 Thanks: 14 Thanked 67 Times in 62 Posts iTrader: (0)	On my car there is very clear labeling of these on the black plastic which covers the lights etc under the bonnet. The inner ones are marked L-R and outer ones Up-Down.