Car: 10G 1.5 Civic Prestige
Join Date: 10th October 2015
Location: Bexhill, Sussex
Thanked 221 Times in 213 Posts
Not much translation needed as the diagram is pretty self explanatory.
Cut the wires that go to the mirror fold motor. (White and black)
Connect the 4 ends to 4 wires on the box (See below)
Connect a wire from the box to the lock signal to the door lock motor (blue)
Connect a wire from the box to the unlock signal to the door lock motor (green)
Connect a wire from the box to 12V permanent live (red)
Connect a wire from the box to 12V ignition switched live (yellow)
Connect a wire from the box to earth (black)
The main problem is getting the 2/3 12V and earth wires (Red, Yellow and Black) into the door.
Colours for mirror motor connections
MM ----- Box
White to Orange
Black to Brown
Colours for mirror motor feed connections
MM ----- Box
White to Grey
Black to White
If you want to make it PnP, then you have to fit two way plugs/sockets to the White and Black wires from the mirror motor.
Bear in mind that the colours may be different on your car, but all the boxes seem to be the same. I have fitted about 10 of them now.
Please use the reply button rather than quoting the whole of this post.
Last edited by M8TJT; 25th July 2018 at 09:31.