Thought I’d start a Mod thread for my car as it seems to be escalating. All comments, suggestions and advice appreciated. I bought the car off Honda (Cannock) back in October 2017, was completely standard and had been through the Honda Approved Standard program so had had a lot of work on it...
Anyone done the valve clearances themselves on FN2??
After getting a new honda rocker gasket Ive took mine apart today knowing i could do them myself after watching all the videos on youtube.... So i thought..
theres no fn2 vids on youtube only ep3's and lads doing them
After fighting just...
Just got two Bosch oil filters for the FN2 from fleabay, thought they are all the same:
To my annoyance they...
Idle at a stop seems fine (800rpm, give or take 10), but when coasting to a stop or downhill in neutral (doesn't matter if in gear with clutch disengaged or in neutral) the idle rpms are all over the place. Car runs fine otherwise, no problems accelerating or anything when driving.
Seen people praise Eibach springs, but they lower the car as well.
Any options for springs that keep stock height? It's already on the low side for my taste.
I guess progressives like Eibach would be nice, given the limited suspension travel.
Had a look at the clutch fluid - not a pretty sight
Anyone know where the slave cyl nipple is?
I've seen one at the front of the engine slightly on the passenger side, a bit low - but wouldn't want to undo anything without being certain.
Do people ever change clutch fluid? Mine is in an...