2006+ Honda Civic Forum banner
1 - 1 of 1 Posts

· Registered
56 Posts
Discussion Starter · #1 ·
I have now made a adapter for pressure bleeding the clutch. Holds pressure only low psi . Not used it yet has only recently changed the fluid. So give it some thought a came up with this. Has you can see from the photos
This is a plastic 1" inch pressure testing bung with a 10mm test point that I have screwed on a Male connection for my Sealey pressure bleeder. It fits inside the reservoir and turn the winged nut down to expand the rubber bellow for a tight seal. There enough room in the reservoir for this to fit. All done for under £10
Hood Automotive lighting Automotive exterior Automotive design Bumper
Jersey Sleeve Glove Automotive tire Tie
Musical instrument Guitar accessory String instrument Hood Motor vehicle
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.