[cammy81]

Hi!

Can anyone help??

Changed a reverse bulb to the 360 bulb, blew fuse number 15. Ok changed the fuse. Tried the 360 bulb again - display went blank and car wouldn't start.
Changed fuse number 9 and now my engine management symbol is constantly display on the dash....any ideas?

Car starts but don't want to drive it just incase

All original bulbs back in the car

 

[mpn_daedalus]

I would imagine it's nothing.

You could disconnect the battery for a few minutes and reconnect it to clear any fault codes, then see if the engine management light comes back.

 

[cammy81]

I'll try this. I know it does the self checks on start up but the light is staying on which is why it's bothering me. And I have only replaced a fuse!!

I would imagine it's nothing.

You could disconnect the battery for a few minutes and reconnect it to clear any fault codes, then see if the engine management light comes back.

 

[Bog]

Check System light can come on after a blown fuse and normally clears itself...

But why would changing a bulb blow the fuse? Dodgy bulb?

 

[cammy81]

I defo think the bulb is dodgy, I'll try disconnecting the battery and see what happens.

Check System light can come on after a blown fuse and normally clears itself...

But why would changing a bulb blow the fuse? Dodgy bulb?

 

[cammy81]

Disconnected the battery and everything seems to be back to normal!! Woop woop

Thanks Guys!

I would imagine it's nothing.

You could disconnect the battery for a few minutes and reconnect it to clear any fault codes, then see if the engine management light comes back.

 

[mpn_daedalus]

Good to hear