2006+ Honda Civic Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hey guys I’m absolutely stuck here!!

So I recently changed my clutch out on my 07 fn2, at same time I replaced knock sensor and rear main oil seal. Now since starting the car I have had multiple codes being thrown but only two lights on dash, EPS and ENGINE. I double checked all plug connections and made sure they were okay.
While driving car revs out to 4.5k and doesn’t not engage VTEC, I have no speedo so thought issue was from VSS, switched over VSS with a known working one and did not fix. Codes being thrown are for BCM, EPS, ENGINE and battery. Car runs and drives fine apart from having no power.
311048
311049
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #3 ·
Charge the battery, change the speed sensor and clear old codes.

Hope for the Best, Prepare for the Worse.
charged the battery before installing back into car and also switched VSS over with a working one but still had no speedo while driving, feeling like it might be replacement ECU as nothing seems to be communicating :/
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top