2006+ Honda Civic Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
Ok so I have a knock sensor fail EML what's the best way to replace it? In from the bottom or some route through the top? Anyone got a guide?

Can see the sensors are not too expensive.

Any tips welcome

Car is off the road till sorted, MOT expires tomorrow.

Cheers
Dazzler

Sent from my Pixel 4 using Tapatalk
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #2 ·
So finally got round to doing this over a mates pit. After removing the undertray had to support the engine and remove the front lower crash bar, only need to do the bolts on the end as it moves enough to get your arm in then, old sensor fell off in 2 bits, was a propper bugger to get it out and a new one in so tight with no space. Not sure if it's any easier than going in from the top tbh.

Cleared the EML will see if it stays off as it was a cheap sensor. Hopefully it will last!


Sent from my Pixel 4 using Tapatalk
 
1 - 3 of 3 Posts
Top