2006+ Honda Civic Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
Hi guys, now again (sorry if I sound like a complete noob)

But I am planning to repaint the rocker cover on my FN2 wrinkle red... Of course I have to take the cover off nuts/coil pack hoses etc... I am just a tad concerned upon looking over the area I can't help but notice this god awful white sealant oozing out of some of the areas shown.. Along with some slight oil stains, there also appears to be a nut missing? Just want to et some feedback on this and is greatly appreciated guys cheers!
319311
 

Attachments

·
Super Moderator
Joined
·
3,665 Posts
the sealant is likely Hondabond, either from new or if the valve clearances have been done since.
there is a rubber seal/gasket in there but some areas need the white stuff to seal fully.
 

·
Premium Member
Joined
·
595 Posts
Iirc that hole not in use. Sealant is normal in that area and slight oil misting is unfortunately also normal.
 
1 - 3 of 3 Posts
Top