2006+ Honda Civic Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
280 Posts
Discussion Starter · #3 ·
The machine printout should show default tolerances as the garage will enter your car type into the machine.
I was just wondering whether the alignment machine's tolerances would be specifically for a car's model or for all the model range and whether these tolerances are from the factory or something that the alignment machine's manufacturer comes up with?

I don't think there's any particular standard settings. The rear can differ from car to car due to the fixed beam suspension. This is why alot of people go and get a fast road set up. Hope this helps
Thanks :thumbsup:

Just wish particular areas of the North East are not riddled with unavoidable potholes! :cry:
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top