2006+ Honda Civic Forum banner
1 - 1 of 1 Posts

Premium Member
422 Posts
I was wondering if anyone is able to provide the standard geometry settings for a standard FN2 Type R before I get my car checked on a Hunter alignment system? :D
The machine printout should show default tolerances as the garage will enter your car type into the machine.

I don't think there's any particular standard settings. The rear can differ from car to car due to the fixed beam suspension. This is why alot of people go and get a fast road set up. Hope this helps
  • Like
Reactions: Jonathan W
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.