Aluminium ones look good, but are fairly soft and prone to stripping. Also they don't last long if you're having your wheels taken on and off often with an impact wrench
I have these in silver and they are fine, as muse said you will need some ball washers.... which tegiwa sell and Butler on here also sells them i think. Never use an impact wrench on them always use a torque wrench and get a long driver bit for them as you don't want to twist them.
Aluminium ones look good, but are fairly soft and prone to stripping. Also they don't last long if you're having your wheels taken on and off often with an impact wrench
Hi most times when starting the car i hear a bad loud'ish grinding sound for 1 to 3 seconds. Car runs fine, just this sound. Some times it doesnt make it, other times it does. I've done over 210k km, so the car isn't new anymore.
Any ideas? Starter motor? PCV?
Any suggestions on what to...
Just wondering whether the FN2 rear calipers are different to the rear calipers on other models, or if they are interchangeable? I know the fronts are different, but unsure about the rears.
Hi all!
I've been searching the internet, but can't seem to find anything relating to the oem markings on k20 injectors besides the oem part number (16450-RRB-003)
The marking on all 4 of my injectors is VB06 BASV
But while i was looking for spare ones i found some on ebay (for a fn2) which...
Just wondering if anyone else has burning oil issues. I've heard honda's burn oil in vtec anyway . If anyone can shed some light would appreciate it a lot
Have fn2 and put a new japspeed 2.5" stainless cat back on while back
today after ripping round for 20/30mins i was feeling the tailpipes just behind rear bumper cause there still catching a little
the passenger side tailpipe was steaming hot - too hot to touch,
the drivers side tailpipe was...
A forum community dedicated to all Honda Civic owners and enthusiasts. Come join the discussion about performance, modifications, engine swaps, troubleshooting, wikis, VTEC, and more!
