[chinery]

Does anyone have the wiring diagram for this nav unit? I feel like I've found them for all the others, but not this one. It does not have a 20-pin connector, which seems to be present on the others. But there is a 20-pin socket on my aftermarket loom.

This manual (for a different connector) maybe suggests that the 24 pin connector on my unit now carries the can information, and I'm wondering if I can wire that up to the 20 pin connector on the Android loom, but I want to check if more than the two pins mentioned in that pdf could be useful...

Huge thanks for anyone who can help (even if it's just anecdotal reports of replacing this HU)

 

[chinery]

Thanks for the reply! You may have seen this already, but this pdf has instructions about hardwiring the phone buttons. I'm probably not even going to try with those, if I can get volume and forward/back I'll be happy.

How did the SWC-23229NAV connect to the Atoto unit? Or does it just have an ISO connector, so plugged straight in? My head unit has a different interface, and a separate can bus decoder. It does also have KEY1/KEY2 wires for SWC but the InCarTec product specifically says that's not compatible.

I'm not worried about reverse camera retention as I'm planning to replace the camera with an upgraded one anyway. SWC is my biggest hurdle now...

I still haven't found a wiring diagram for the 24 pin connector on this sat nav, but I've cross referenced the active pins on the 20 pin connector on my harness with the ones in the wiring diagram for the non-nav units. I think the only pins that were present on both were for iMid communication, and as you say, I doubt the Android unit supports that anyway. So I am going to try modifying the harness as described in that InCarTec PDF, take those two can high/low cables and plug them into the 24 pin connector and see if the SWC starts working. Feels like a stab in the dark as it will leave lots of cables from the harness unplugged, but you never know!

 

[chinery]

Is this the one you are looking for?

Thanks but no, it’s this one, and I’ve circled the connector of interest.

It has two fans, and 9 ports total. The circled connector has 24 pins, the ones in that diagram have 22, 17, or fewer.

(The port that carries power and audio is directly below the circled one and also has 24 pins, that one shows up on many other models too. The 24P connector I’m looking for just has two rows of equal sized pins that are offset.)

 

[chinery]

That's interesting about just wiring to Key 1. I suppose it's a last resort option if I want to buy a whole extra adaptor. Haven't had time recently but I'm going to try wiring to the 24 pin adaptor best I can and cross my fingers.

Strange about the bluetooth, does the Atoto unit not just create a new BT device you can pair to? That's how it works with mine. That's one bit that does work!

 

[chinery]

Out of interest Ian, do you know what the cable with the red RCA jack on the left is for? Do you remember where you plugged it in on your head unit? Subwoofer maybe...? (Was hoping that'd just work via the FL/FR/BL/BR normal audio outputs)